Topic 1, Exam Pool A
Which command is used to check IP SLA when an interface is suspected to receive lots of traffic with options?
A.
show track
B.
show threshold
C.
show timer
D.
show delay
show track
What is a limitation of IPv6 RA Guard?
A.
It is not supported in hardware when TCAM is programmed
B.
It does not offer protection in environments where IPv6 traffic is tunneled
C.
It cannot be configured on a switch port interface in the ingress direction
D.
Packets that are dropped by IPv6 RA Guard cannot be spanned
It does not offer protection in environments where IPv6 traffic is tunneled
Refer to the exhibit.
Which control plane policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is sent at higher rate?
A.
policy-map SHAPE_BGP
B.
policy-map LIMIT_BGP
C.
policy-map POLICE_BGP
D.
policy-map COPP
policy-map COPP
Drag and drop the addresses from the left onto the correct IPv6 filter purposes on the right.
What is a prerequisite for configuring BFD?
A.
Jumbo frame support must be configured on the router that is using BFD.
B.
All routers in the path between two BFD endpoints must have BFD enabled.
C.
Cisco Express Forwarding must be enabled on all participating BFD endpoints.
D.
To use BFD with BGP, the timers 3 9 command must first be configured in the BGP routing process.
Cisco Express Forwarding must be enabled on all participating BFD endpoints.
Refer to the exhibit.
Which configuration denies Telnet traffic to router 2 from 198A:0:200C::1/64?
A.
Option A
B.
Option B
C.
Option C
D.
Option D
Option A
Refer to the exhibit.
After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1. Which action can the engineer take to solve the issue so that all the PCs are reachable?
A.
Set the administrative distance 100 under the RIP process on R2.
B.
Filter the prefix 10.1.1.0/24 when redistributed from OSPF to EIGRP.
C.
Filter the prefix 10.1.1.0/24 when redistributed from RIP to EIGRP.
D.
Redistribute the directly connected interfaces on R2.
Set the administrative distance 100 under the RIP process on R2.
Refer to the exhibit.
During troubleshooting it was discovered that the device is not reachable using a secure web browser. What is needed to fix the problem?
A.
permit tcp port 443
B.
permit udp port 465
C.
permit tcp port 465
D.
permit tcp port 22
permit tcp port 443
Refer to the exhibit.
Drag and drop the credentials from the left onto the remote login information on the right to resolve a failed login attempt to vtys. Not all credentials are uf SLA by defining frequency and schedulingsed
Which method changes the forwarding decision that a router makes without first changing the routing table or influencing the IP data plane?
A.
nonbroadcast multiaccess
B.
packet switching
C.
policy-based routing
D.
forwarding information base
policy-based routing
An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table. What should be configured to accomplish this task?
A.
set ip next-hop
B.
set ip default next-hop
C.
set ip next-hop recursive
D.
set ip next-hop verify-availability
set ip default next-hop
After some changes in the routing policy, it is noticed that the router in AS 45123 is being used as a transit AS router for several service provides. Which configuration ensures that the branch router in AS 45123 advertises only the local networks to all SP neighbors?
A.
Option A
B.
Option B
C.
Option C
D.
Option D
Option D
Page 9 out of 47 Pages |
Previous |