An engineer is implementing OTV on a transport that supports multicast. The solution needs to meet the
following requirements:
• Establish adjacency to the remote peer by using multicast.
• Enable OTV advertisements for VLAN 100 to the other site.
Which two commands should be configured to meet these requirements? (Choose two.)
A.
otv site-vlan 100
B.
otv data-group 232.2.2.0/28
C.
otv use-adjacency-server 172.27.255.94
D.
otv extend-vlan 100
E.
otv control-group 232.1.1.1
otv data-group 232.2.2.0/28
otv control-group 232.1.1.1
Which mroute state is created when Bidirectional PIM is deployed at a site?
A.
MVPN Type-6
B.
*,G
C.
MVPN Type-7
D.
S,G
*,G
A network engineer must determine the cooling requirements for a Cisco UCS C-Series Rack Server. The
server with PCIe cards is configured with a fan configuration policy. Which configuration should be used for
the fan policy of the server?
A.
Option A
B.
Option B
C.
Option C
D.
Option D
Option A
A server engineer wants to control power uses on a Cisco UCS C-series rack server down to the component level. Which two components support specific power limits? (Choose two.)
A.
memory
B.
graphic card
C.
processor
D.
network controller
E.
storage controller
memory
processor
A small remote office is set to connect to the regional hub site via NSSA ASBR. Which type of LSA is sent to the remote office OSPF area?
A.
type 7 LSA
B.
type 3 LSA
C.
type 1 LSA
D.
type 5 LSA
type 7 LSA
An engineer must recover configuration on a Cisco MDS 9000 Series switch from a previous version that was backed up to bootflash and then verify the restoration. Drag and drop the commands on the left to the correct order on the right.
The FCoE technology is used in a data center and the MDS switches are configured as Fibre Channel Forwarders. What configuration should be applied to an MDS switch in order to be used as the best switch to connect by the CNAs in the fabric?
A.
fcoe fcf-priority 1024
B.
fcoe fcf-priority 512
C.
fcoe fcf-priority 0
D.
no fcoe fcf-priority
fcoe fcf-priority 0
Which statement describes monitoring Fibre Channel traffic on a Cisco UCS 6332 Fabric Interconnect?
A.
Fibre Channel traffic is monitored only on one vHBA per server.
B.
The destination port for monitoring must be an unassigned Fibre Channel port.
C.
The monitoring of Fibre Channel traffic is limited to the default VSAN.
D.
Fibre Channel traffic is capable to be monitored as it is encapsulated as FCoE.
Fibre Channel traffic is capable to be monitored as it is encapsulated as FCoE.
Which statement about monitoring Fibre Channel traffic on a Cisco UCS 6332 Fabric Interconnect is true?
A.
The monitoring of Fibre Channel traffic is limited to the default VSAN.
B.
Fibre Channel traffic can be monitored only on one vHBA per server.
C.
The destination port for monitoring must be an unassigned Fibre Channel port.
D.
ibre Channel traffic can be monitored as it is encapsulated as FCoE.
Fibre Channel traffic can be monitored only on one vHBA per server.
A Cisco MDS 9000 series storage Switch has reloaded unexpectedly. Where does the engineer look for the latest core dump file?
A.
/mnt/core
B.
/mnt/pss
C.
/mnt/logs
D.
/mnt/recovery
/mnt/pss
What occurs when running the command install deactivate <filename> while a software maintenance upgrade
A.
The current set of packages is committed.
B.
The package is removed from the switch.
C.
The package features for the line card are disabled.
D.
The current upgrade stops.
The package features for the line card are disabled.
Which configuration generates a syslog message when CPU utilization is higher than 60%?
A.
event manager applet HIGH-CPU
event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type exact entry-op gt 60 poll-interval 5 action 1.0 syslog priority notifications msg "cpu high"
B.
event manager applet HIGH-CPU
event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type exact entry-op lt 60 poll-interval 5 action 1.0 syslog priority notifications msg "cpu high"
C.
event manager applet HIGH-CPU
event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type next entry-op gt 60 poll-interval 5 action 1.0 syslog priority notifications msg "cpu high"
D.
event manager applet HIGH-CPU
event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type next entry-op lt 60 poll-interval 5 action 1.0 syslog priority notifications msg "cpu high"
event manager applet HIGH-CPU
event snmp oid 1.3.6.1.4.1.9.9.109.1.1.1.1.6.1 get-type exact entry-op gt 60 poll-interval 5 action 1.0 syslog priority notifications msg "cpu high"
| Page 4 out of 19 Pages |
| 123456 |
| 350-601 Practice Test Home |
Real-World Scenario Mastery: Our 350-601 practice exam don't just test definitions. They present you with the same complex, scenario-based problems you'll encounter on the actual exam.
Strategic Weakness Identification: Each practice session reveals exactly where you stand. Discover which domains need more attention, before Implementing Cisco Data Center Core Technologies (350-601 DCCOR) exam day arrives.
Confidence Through Familiarity: There's no substitute for knowing what to expect. When you've worked through our comprehensive 350-601 practice exam questions pool covering all topics, the real exam feels like just another practice session.
Copyright © All Rights Reserved